Selectline Cleaner

Flush the machine with clean water immediately after each marking session, before the paint dries. Use Selectline Cleaner periodically for preventive maintenance, when switching from colored paint back to white and for heavily soiled components. Dried paint in hoses, filters and nozzles can cause blockages and disrupt the spray pattern.

Three concentrations: 1:6 with water for routine cleaning and preventive maintenance, 1:1 for intensive cleaning of heavily soiled components, and undiluted for nozzles, hoses and persistent paint residue. Apply, allow approximately one hour to work, brush where necessary, then rinse thoroughly with clean water before returning the component to service.

Yes. Remove the nozzle and filter according to the machine instructions. Soak them in undiluted Selectline Cleaner for about an hour, brush away loosened paint and rinse with clean water. Clean the inside where accessible. Never use a metal pin or wire to clear the nozzle opening: it can enlarge the opening and permanently affect the spray pattern and line width.

Selectline Cleaner is a water-based, non-flammable solution. Wear protective gloves and safety glasses when handling it and avoid contact with skin and eyes. Read the Safety Data Sheet before first use for complete handling instructions. Dispose of unused product and packaging through an appropriate collection point for hazardous or special waste, not into a drain or onto the pitch.

Flush the machine before switching. Place the suction rod in clean water with Selectline Cleaner, open the priming valve and run the machine until the rinsing water runs clear, then flush the spray head. Remove the nozzle holder, nozzle and filter and clean them separately with undiluted Cleaner. Colored residue left in a hose or nozzle will tint the first metres of the next white line. Selectline Cleaner is suitable for internal and external components, so the same solution cleans the chassis and spray assembly.